When adding trees and shrubs to your landscape, planting in the fall offers several benefits. It's an ideal time for you, as all the hard gardening work of spring and the upkeep of summer will be winding down - plus it's the best time for the tree. The combination of warm soil and cool air stimulates root growth to help your tree or shrub get established before the ground freezes. In the fall, trees and shrubs are either sold in containers or with root balls, where the root and soil is wrapped in burlap (often called "balled-and-burlapped"). Planting them is easy. Just follow these simple steps.
Healthy trees and shrubs will last for decades, so consider your longer-term landscaping goals and how the full-grown trees and shrubs will fit in. Consider trees and shrubs that will provide different features year-round, such as fruit in summer and changing leaf colors in fall. For beautiful blossoms, consider a redbud or ornamental cherry tree in Northern regions, crape myrtle in the Southeast or desert willow in the Southwest.
Give the trees and shrubs plenty of room to grow, making sure you research the plant's full-grown size. Refer to the information that comes with the tree or ask your garden center for recommendations. Use a tape measure to gauge how your new trees and shrubs will fit into your existing landscaping. You don't want to plant a tree too close to your home or neighbor's property, which may cause damage to the buildings and tree roots.
Now you're ready to dig. Create a hole that's twice as wide as your container and deep enough that the root ball's soil line sits slightly above ground level.
Your new trees and shrubs need a good home in nutrient-rich soil. When planting, blend in Miracle-Gro® Garden Soil for Trees and Shrubs with your native soil in a 50:50 ratio. Make sure the soil line of the root ball is slightly higher than ground level. If you have a balled-and-burlapped tree, you'll want to remove any twine and burlap from the top of the root ball as well as any parts of the wire cage that will be above ground after planting. Leave the rest of the burlap, twine, and wire cage around the root ball in tact; it will break down in the soil over time. Then, start filling the hole with your soil mixture. When the hole is half-full, water the tree, then fill in the remaining soil. Finally, pull some soil away from the tree trunk to create a donut-shaped ring of soil that will act like a basin to hold water and funnel it to the tree roots, and water moderately again.
Most new trees and shrubs will benefit from mulch, which helps conserve moisture in the soil. Using a bark-based mulch layer 3 inches of mulch on top of the soil, leaving about 1 to 2 inches of space around the trunk to prevent disease.
When watering your new tree or shrub, keep in mind that water needs will be considerable at first. But since you're planting in fall, those needs will soon taper off until spring. As your trees and shrubs are becoming established, water two or three times a week, adjusting for weather and soil condition. Go for infrequent but generous deep soakings.
To get your new tree or shrub off to a good start apply Miracle-Gro® Quick Start® Planting & Transplant Starting Solution after planting to help stimulate root growth. The following spring, apply Miracle-Gro® Shake 'n Feed® Flowering Trees & Shrubs Continuous Release Plant Food.